Altronix eFlow4NA8V Access Power Controller w/ Power Supply/Charger, 8 Fused Relay Outputs, 12/24VDC, 4A, Aux Output, FAI, 220VAC, BC400 Enclosure

Technical Specification

Features:

Make: Altronix
Model code: eFlow4NA8V
Input Voltage: 220 V AC
Output Voltage: 12 V DC or 24 V DC
No of Outputs: 8

Additional info:

Altronix eFlow4NA8V unit distribute and switch power to access control systems and accessories. It converts a 220VAC 50/60Hz input into eight (8) independently controlled 12VDC or 24VDC fuse protected outputs with a total of 4A continuous supply current. These power outputs can be converted to dry form "C" contacts. Outputs are activated by an open collector sink or normally open (NO) dry trigger input from an Access Control System, Card Reader, Keypad, Push Button, PIR, etc. Unit will route power to a variety of access control hardware devices including: Mag Locks, Electric Strikes, Magnetic Door Holders, etc. Outputs will operate in both Fail-Safe and/or Fail-Secure modes. The FACP Interface enables Emergency Egress, Alarm Monitoring, or may be used to trigger other auxiliary devices. The fire alarm disconnect feature is individually selectable for any or all of the eight (8) outputs.

Contact manufacturer Contact manufacturer Datasheet Datasheet

Make	Altronix
Manufacturer	Altronix
Category	Video Surveillance>Power supplies & batteries
Model code	eFlow4NA8V
Input Voltage	220 V AC
Output Voltage	12 V DC or 24 V DC
No of Outputs	8
Power Supplies & Batteries	Yes
Environmental Specifications	Operating Temperature C: 0 ~ 49 C (32 ~ 120 F ) Operating Humidity %: 85
Physical Specifications	Dimension mm: 305 x 394 x 114 Weight g: 3920
Additional info	Altronix eFlow4NA8V unit distribute and switch power to access control systems and accessories. It converts a 220VAC 50/60Hz input into eight (8) independently controlled 12VDC or 24VDC fuse protected outputs with a total of 4A continuous supply current. These power outputs can be converted to dry form "C" contacts. Outputs are activated by an open collector sink or normally open (NO) dry trigger input from an Access Control System, Card Reader, Keypad, Push Button, PIR, etc. Unit will route power to a variety of access control hardware devices including: Mag Locks, Electric Strikes, Magnetic Door Holders, etc. Outputs will operate in both Fail-Safe and/or Fail-Secure modes. The FACP Interface enables Emergency Egress, Alarm Monitoring, or may be used to trigger other auxiliary devices. The fire alarm disconnect feature is individually selectable for any or all of the eight (8) outputs.
Download PDF version Download PDF version